Dragon Ball Vegeta Bottom 達爾底座

本次作品是七龍珠裡面的達爾，同樣的我將它上色成超級賽亞人的樣子，整體看起來真的是滿不錯的，眼睛與眉毛有特別下工夫去上色。 列印過程並不會太困難，只有在底部開邊緣以及支撐，幾乎上成功率都滿高的，特別注意的地方是比例，建議依照原設計比例或是變大，盡可能不要再縮小，避免一些地方太細小而會有印不出來的現象。 這次在做了一點點小實驗，就是在上色後的質感測試，分享一下測試結論，發現到當打磨工序做得越好，後續上色後的質感相對會越好，因此雖然打磨很累很辛苦，但是它跟後續的質感是呈正比的，當然上色也要搭配的好，若沒有製作時間限制，是很值得花多點時間去打磨的。 上色的部分真的是不容易，要很多耐心去處理，雖然達爾顏色並不多但真的是不好塗，意外發現藍色跟綠色這兩種顏色特別不好塗呢。 This work is Vegeta in Dragon Ball. In the same way, I paint it like a Super Saiyan. The overall look is really good, and my eyes and eyebrows have been specially worked to paint. The printing process is not too difficult, only the edges and supports are opened at the bottom, and the success rate is almost high. Special attention is paid to the ratio. It is recommended to follow the original design ratio or increase it. Some places are too small to print. I did a little experiment this time, that is, the texture test after coloring, sharing the test conclusio, and found that the better the polishing process, the better the texture after subsequent coloring, so although the polishing is very tired It is hard work, but it is proportional to the texture of the follow-up. Of coue, the color should be matched well. If there is no production time limit, it is worth spending more time to polish. The coloring part is really not easy. It takes a lot of patience to deal with it. Although there are not many Vegeta colo, it is really not easy to paint. I accidentally found that the two colo of blue and green are particularly difficult to paint.