JXD S192 聲室

This is a 3d printable .STL mod part for the JXD S192 Android game tablet to get better bass and sound out of the system. It uses (2) 13 x 18mm "cellphone" type speake. They are available through electronics sites such as "Digikey", just search in speake, the chamber can accept up to 4.5mm thick speake. They must then be cemented into the chamber with glue such as epoxy. ALL seams around the speaker including the ones toward the front and where the wires come out must be sealed airtight with glue to chamber otherwise you can get distortiopoor bass. The mod requires user to notch out game button PCB to accommodate chamber and requires soldering. This is no amateur mod, do not attempt if not experienced with such things. You will void warranty and you could break the unit if not done right. Do at your own risk. This includes chambe for left and right side, cut and remove "tree" to separate. One important thing to know is that you need to make sure all of the powder is out of the chambe. You will have to likely tap out the powder until it stops (using a strong flashlight through the model you can actually see the powder still trapped). The holes at the ends are to poke out powder from the bass ports. Use a wire to get the powder out until you can blow into the port on the front and get air flow out the back. Those holes under the square"bulbs" should then be plugged with glue such as epoxy (the one sin front stay open to allow bass out. A can of that compressed air helps with you don't know what this is, you don't need it!