地下城：洞穴-鋸齒狀洞穴

Dungeoticks: Caver - a new modular cavern design system that is fast and easy, and designed to use with a gridded battle map! This project is being supported by my Kickstarter, The Skyless Realms This Set: Jagged Caver This set contai 3 walls, 2 wall ends and an entrance in a jagged, sharp columnar look and feel. The set is in two styles: "flat", which is more like sheer ice, and "rocky" which (as the name implies) is more of a rocky look feel. This set is designed for use in multiple cases, such as lava rock, glowing abyssal, and icenow caver. You can see 3 different print/paint strategies in the pics - the abyssal and lava ones were printed in black PLA and the icenow was printed in tralucent then washed with blue and painted a little. For couple you can use the ones from the Dry Caver set and paint to match. Check out the full Dungeoticks: Cavern collection HERE - I will be releasing many more themed sets as the Skyless Realms Kickstarter continues! What the hell is a Dungeotick: Cavern? Tile sets have their place, but for organic caver they are unruly and hard to use. To that end, I developed Dungeoticks - a "2.5d" terrain system built of walls and entrances to build out your caver (on top of a battle map/mat, table, etc) with the focus on quick/easy setup, portability, player visibility, and easy printing/painting. The connection system is a simple drop-in rotating joint that requires no additional clips or fastening mechanism, and allows the walls to move to fit organic shapes. The goals of this system are: Faster and easier than complete tile sets to print, paint, and setup Reusable, flexible, and combinable with very minimal teardown / setup Easy storage, traportation, and stacking when not in use Create an 3rd dimeion effect without the need for full floowalls (by leveraging short walls and full-height doo, colum, etc) Offer nearly-zero visual impairment or sight blocking for playe on the table. Not sacrifice desigaesthetics, but make the pieces beautiful for playe to look at and full of detail without overcomplicating painting. Harken back to an old-school "runehammer-esque" feel when used on the table. Dungeoticks: Caver contain a set of base cotruction items to build themed organic caver of all types including walls, couple, and entrances. They are designed to work with 1" grid systems with limited loss of playable floor space in the interior. A typical "stick" prints in about 1 hr and an entrance in about 1.5 h. They require no support and minimal infill, and you can fill your print bed up with these overnight and print a full set in as little as a few days. Perfect for adding a 3rd dimeion to your last-minute one shot! Printing Notes All pieces are designed to be printed best @ .16mm layer height, but anything up to .3mm should work OK. They require little infill (10% or so) but I peonally like 20-30% so they have a little weight to them. No supports are needed for any of the pieces. NOTE- you can mirror every piece in your slicer to get more variatio